●Place of Origin:Fujian, China (Mainland)
●Shaping Mode:Plastic Injection Mould
●Product Material: All kinds of Plastic raw material ABS Plastic Injection
ABS Plastic Injection
Since moulds have been expensive to manufacture, they were usually only used in mass production where thousands of parts were being produced. Typical moulds are constructed from hardened steel, pre-hardened steel, aluminium, and/or beryllium-copper alloy. The choice of material to build a mould from is primarily one of economics; in general, steel moulds cost more to construct, but their longer lifespan will offset the higher initial cost over a higher number of parts made before wearing out. Pre-hardened steel moulds are less wear-resistant and are used for lower volume requirements or larger components by ABS Plastic Injection.
Why Choose Julier