Plastic Part Design for Injection Molding Electronic Knobs Cost

Plastic Part Design for Injection Molding Electronic Knobs Cost

●Place of Origin:Fujian, China (Mainland)
●Brand Name:JULIER
●Shaping Mode:Plastic Injection Mould
●Product Material: All kinds of Plastic raw material

Send Inquiry

Product Details

Plastic Part Design for Injection Molding

Plastic Molding Description                                                                                    

Lack of holding pressure (holding pressure is used to pack out the part during the holding time). Filling too fast, not allowing the edges of the part to set up. Also mould may be out of registration (when the two halves don't centre properly and part walls are not the same thickness). The provided information is the common understanding, Correction: The Lack of pack (not holding) pressure (pack pressure is used to pack out even though is the part during the holding time). Filling too fast does not cause this condition, as a void is a sink that did not have a place to happen. In other words, as the part shrinks the resin separated from itself as there was not sufficient resin in the cavity. The void could happen at any area or the part is not limited by the thickness but by the resin flow and thermal conductivity, but it is more likely to happen at thicker areas like ribs or bosses. Additional root causes for voids are un-melt on the melt pool.

Our Company                                                                                                           

polymer molding plastic high pressure injection moldings company

polymer molding plastic high pressure injection moldings company

Our Service                                                                                                                   

polymer molding plastic high pressure injection moldings company

Plastic Part Design for Injection Molding

Our Certifications                                                                                                          

polymer molding plastic high pressure injection moldings company

Customers Photo                                                                                                         

Favorable comments 1.png

Favorable comments 2.png

FAQ                                                                                                                                

图片.png

 Why Choose Julier                                                                                                      

     polymer molding plastic high pressure injection moldings company


Related Products

Inquiry

  • Your Name:
  • *E-mail:
  • Phone:
  • Company:
  • Title:
  • *Content: